9950 Dual Channel Transmitter

2250 Hydrostatic Signet Flow Sensors

The 9950 SmartPro® Dual Channel Transmitter is a two channel controller that supports two sensors of same or different types in one instrument. The sensor types supported by the 9950 are Signet Flow, pH/ORP, Conductivity/Resistivity, Salinity, Temperature, Pressure, Level, Dissolved Oxygen, and devices that transmit a 4 to 20 mA signal with the use of the 8058 iGo® Signal Converter.

Simplified monitoring made even better with these new (Gen 3) features!

Conductivity Module for monitoring two different readings
Modbus Module for easy connections to existing networks
Automatic measurement of pH glass impedance
Selectable parameters for broken glass detection

The 9950 includes advanced features such as derived functions, advanced multiple relay modes, and timer based relay functions. Derived functions allows for the control of a relay or current loop with the sum, delta (difference), or ratio of two measurements, for example delta pressure and delta temperature. Multiple relay modes allow up to three signals to be used for the control of a single relay. This can be any combination of analog and binary inputs. The timer relay modes allow a relay to be activated on a repeating basis from every minute to once every 30 days. Weekday timer mode allows a relay to be energized on a specific day or days of the week at a specific time.

WHERE TO BUY?
 
9950 Relay Module

9950 Relay Module

Ability to interface up to four binary inputs. The binary inputs are compatible with either open collector or mechanical contacts. The binary inputs can supply power to the four inputs or accepts powered outputs from external devices. These inputs can be used with level switches, flow switches, pressure switches or other devices.

The inputs can be used to directly control the relays of the 9950 or can be used in combination with the measurement readings for advanced control of your process.

WHERE TO BUY?
 
9950 Single Channel Conductivity Module

9950 Single Channel Conductivity Module

The 9950 Single Channel Direct Conductivity/Resistivity module is compatible with all Signet Conductivity electrodes and can be used for all your Conductivity/Resistivity, and Salinity measurements. Up to two Single Channel Direct Conductivity modules can be installed in a 9950 transmitter.

WHERE TO BUY?
 
You can find different styles of like 2250 Hydrostatic Sensor | Related Searchs: Signet Flow Sensors